Aluminum Die Casting plays an important role in the current industry. It has a very wide range of uses in many industries. Society is constantly developing, and people’s living needs are getting higher and higher. The aluminum dies casting process The demand is also constantly increasing.

The main advantages of Aluminum Die Casting

  1. Aluminum die-casting parts are beautiful in appearance and light in weight and can be easily transported during operation. It is also a great advantage to use in automobiles.
  2. The density of aluminum alloy is obviously lower than that of cast iron, cast steel, etc., but its strength and corrosion resistance is much higher. Therefore, under the same load and weight, the use of aluminum die-casting can greatly reduce the structural weight.
  3. For the surface of aluminum alloy, its surface gloss is very good, and it also performs well in casting performance.

The mechanical properties and tensile strength of aluminum die-castings are large when the material is broken during production. To a certain extent, its elongation is a measure of the brittleness and plasticity of the material. The hardness is the surface of the material against hard objects. Resistance to plastic deformation caused by press-in or friction.

Aluminum dies castings are given priority to sand casting. The main reason is that sand casting has a lower cost than other casting methods, a simple production process, and a short production cycle. When the wet type cannot meet the requirements, consider using the clay sand surface dry sand type, dry sand type or other sand types. The casting method of aluminum castings should be compatible with the production batch. Low-pressure casting, die casting, centrifugal casting and other casting methods are only suitable for mass production because of the high prices of equipment and molds. Cast aluminum can be single-piece casting or mass production.

Yuyao Weilong Industry Co., Ltd. is an Aluminum Die Casting Factory with a variety of Die Castings products. Welcome to visit our official website.