The mobile phone signal jammer is a new type of information security product. It uses a specific electromagnetic signal to form a shielding network in the place that needs to be protected, so that the mobile phone cannot receive data from the base station and cannot establish contact with the base station. About the signal jammer, you need to know the following four things:

1. What needs to be done before the installation of the mobile phone signal jammer equipment:

1. Before installing this equipment, be sure to install the antenna correctly according to the signs, and then turn on the power to prevent the machine from being burned out.

2. Before installing the equipment, you should understand the orientation of the base station, and try to make the direction of the shield follow the direction of the base station.

3. When installing equipment, pay attention to whether there are metal objects within 1 meter around the machine to prevent the formation of signal reflection, which will affect the shielding effect.

4. In special environments such as gas stations, gas stations, etc., explosion-proof machines should be installed.

5. The height of the device is preferably 1.8-2 meters. It can be placed directly on the table, on the wall or on the ceiling. It is better that the antenna and the ground are straight.

6. If it is installed indoors, you should pay attention to whether the transmission frequency of the existing wireless equipment in the room causes co-channel interference.

7. The tolerance and safety interval of anti-interference interference of existing indoor fine instruments must be considered.

8. If an amplifier such as signal enhancement is installed in the room, it is not suitable to install a shield.

9. Fully understand the boundary between the shielded area and the non-shielded area.

cell phone jammer

Second, the installation of mobile phone signal jammer site survey

1. Knowing the signal strength of the field is very important for the installation of the signal jammer. Because there are many kinds of signals in an environment, and the strength of each kind of signal is not the same, so knowing the signal strength of the scene can design the device jammer in a targeted manner.

2. In the absence of survey equipment, it is necessary to know the status of the surrounding base stations of the device address, how far is the visual distance, what base station (mobile, China Unicom, CDMA, 3G, 4G, 5G and other base stations), and the direction of the antenna of the base station is Which way to point. In general, base stations in cities are mostly built on the tops of taller buildings, and in suburbs or villages, they are mostly iron towers.

3. If there is survey equipment, it is only necessary to record the signal strength of multiple indoor and outdoor points on site in detail.

3. Mobile phone signal jammer equipment installation

1. According to the results of the survey, reasonable matching of different signals has reached the ideal situation, and the degree of interference in the unshielded area and the impact on the surrounding base stations should be fully considered.

2. Confirm the schematic diagram of the installation. During the actual installation process, first install the place with strong signal (that is, the place closest to the base station), select the directional antenna, and start the installation in the direction of the base station antenna.

3. Considering the floor height of the shielded area, because the high-level signal is better than the bottom layer, choose the device order from top to bottom to achieve the best shielding effect.

4. Fully consider the anti-interference of PHS base stations. PHS base stations generally have relatively low power, and PHS has no uplink and downlink lines.